Articlebronze2014

Distortion effects in primary calibration of low-frequency accelerometers

21 citations0/0 files storedMetrologia

No readable copy stored yet — this record is metadata only.

No open-access location is known for this record yet.

Literature note Cite in a project Citation map

Scientific Measurement and Uncertainty Evaluation Advanced Measurement and Metrology Techniques Advanced Electrical Measurement Techniques

Abstract

According to ISO 16063-11 (1999), at frequencies below 1600 Hz primary calibration of accelerometers may employ two methods: fringe counting or sine approximation. During a recent intercomparison (APMP.AUV.V-S1) small but systematic differences were found between the results obtained by using these two methods, and by the use of different amplifier modes to drive the shaker at frequencies between 0.5 Hz and 20 Hz. The influences of distortion and noise on the two methods are explored. The results and a discussion of the differences are presented in this paper.

Paper brief

Loading…

Cite this work

Citation unavailable for this work.

BibTeX RIS CSL-JSON

No public copy is stored for this record, so only the metadata is cited.

Citations in this library

Citation map →

Stored only when both papers are in the corpus — 21 citations exist upstream.

References

2015Kalibracja przetworników drgań na podstawie normy ISO 16063-21: Methods for the calibration of vibration and shock transducers – Part:21 Vibration calibration by comparison to a reference transducer

Cited by

2021Measurement Uncertainty in Primary Calibration of Accelerometer Complex Sensitivity at Low Frequencies

Explore the map →

Papers that cite the same references — the relational fallback while embeddings are still backfilling.

Imported from OpenAlex (CC0) — nothing here is generated.